Since last week, I have been working on the current amplifier for the induction charger. We decided to abandon using the TPS53313 step down voltage regulator-current amplifier IC (rated at a maximum of 6A continuous output current) because we found that supplying +5V to a 3.7V LiPo battery was possible and safe. Additionally, charging a LiPo battery at 6A was found to be dangerous; the battery should be charged at 25% of the capacity rating (.25 x C), or .25 x mAh. In the case of the 6600mAh battery, it should be recharged at a rate of 1.65A or less. The last reason is that dealing with a surface mount device (SMT) is a bit difficult. I started out using a BJT NPN transistor (model: 2N3904), something I was most familiar with. However, its datasheet states that it has a 200 mA maximum continuous collector current rating. This is a significantly low current. Most, if not all, fast charging adapters today have a 2 A charging rate. While I don’t want to charge the LiPo batteri